/
Configuring Statistical packet-based sampling with sFlow
Use https://seceonhelp.freshdesk.com/support/login to access updated Knowledge Base Articles, Submit Technical Support Tickets and Review Status of submitted support tickets.
Configuring Statistical packet-based sampling with sFlow
This document includes the steps to configure the statistical packet-based sampling with sFlow.
- Configure the sFlow receiver IP address
- Select Monitoring > sFlow > Advanced > sFlow Receiver Configuration.
- Select the 1 check box.
- In the Receiver Owner field, enter NetMonitor.
- In the Receiver Timeout field, enter 31536000.
- In the Receiver Address field, enter 168.10.2.
A screen similar to the following will display. - Click APPLY.
A screen similar to the following will display again.
2.Configure the sampling ports sFlow receiver index, sampling rate, and sampling maximum header size.
a.Select Monitoring > sFlow > Advanced > sFlow Interface Configuration.
b.In the Sampling Ratefield, enter 1024.
c.In the Maximum Header Size field, enter 64.
d.Click Apply
, multiple selections available,
Related content
Configuring sflows
Configuring sflows
More like this
Configuring netflows through command line for Cisco L3 switches
Configuring netflows through command line for Cisco L3 switches
Read with this
Configuring sflow from Extreme Switches
Configuring sflow from Extreme Switches
More like this
Configuration of sflow from Plexxi switches
Configuration of sflow from Plexxi switches
Read with this
Aruba- Adding an sFlow Configuration
Aruba- Adding an sFlow Configuration
More like this
Device Config: Alcatel-Lucent OmniSwitch 6800 Series- Sflow Export
Device Config: Alcatel-Lucent OmniSwitch 6800 Series- Sflow Export
More like this
Seceon Inc. All rights reserved. https://www.seceon.com