Use https://seceonhelp.freshdesk.com/support/login to access updated Knowledge Base Articles, Submit Technical Support Tickets and Review Status of submitted support tickets.
Oracle Configuration
- Collect and Control Engine
- Customer Success & Engineering (Unlicensed)
Overview
Oracle Configuration collects client configuration information and uploads it to the Oracle repository. When client configuration data is uploaded regularly, customer support representatives can analyze this data and provide better customer service.
We are providing steps to integrate your Oracle with Seceon SIEM to have Comprehensive visibility and Proactive Threat Detection in your Environment. There will be a log transfer between your firewall to APE(Analytics and Policy Engine) via CCE (Collection and Control Engine ).
Pre-Requisite
Note: SELinux must be disabled else rsyslog will be denied access to the Oracle logs.
Steps Of Configuration
1. Open the /etc/selinux/config file and set the SELINUX mod to disabled:
Open the /etc/selinux/config file and set the SELINUX mod to disabled:
# This file controls the state of SELinux on the system. # SELINUX= can take one of these three values: # enforcing - SELinux security policy is enforced. # permissive - SELinux prints warnings instead of enforcing. # disabled - No SELinux policy is loaded. SELINUX=disabled # SELINUXTYPE= can take one of these two values: # targeted - Targeted processes are protected, # mls - Multi Level Security protection. SELINUXTYPE=targeted
2. Save the file and reboot your Rocky Linux system with:
sudo shutdown -r now
3. Once the system boots up, verify the change with the sestatus command:
sestatus
4. The output should look like this:
SELinux status: disabled
RSyslog Setup
Log in to the Oracle server as root.
Run the command : vi /etc/rsyslog.conf
Add the lines as below:
$ModLoad imfile
$InputFilePollInterval 1
#### GLOBAL DIRECTIVES ####
$InputFileName rdbms\orcl\orcl\trace
$InputFileTag oracle_logs
$InputFileStateFile state-oracle-access
$InputRunFileMonitor
After adding, configure CCE-IP at the end of file:
*.* @CCE_IP:514
# ### end of the forwarding rule ###
In the place of CCE IP put you actual CCE IP
Verification
Verification through UI
STEP1: Login to UI >> SYSTEM>> LOGS AND FLOWS COLLECTION STATUS .
STEP 2: >> LOGS AND FLOWS COLLECTION STATUS .
Verification through CCE sever
Login to the server as seceon user and run the below command
sudo tcpdump -i any host 514 and host <IP address> -AAA”
Related articles
Filter by label
There are no items with the selected labels at this time.
Related content
Seceon Inc. All rights reserved. https://www.seceon.com