Overview

Configure the logs to be sent to the remote syslog server so that the disk space on the UTM is conserved. You can also monitor, analyze the logs on the syslog server independently. Before configuring the remote syslog server on the UTM appliance, you must ensure that the remote server is up and running and the UTM appliance is able to connect to the remote server.

Steps Of Configuration

Adding a remote syslog server

1. Navigate to Logs and Reports > Settings > Remote Syslog Server.

Open

2. Click the + icon to add a new Syslog server. The Add server dialog box is displayed.

3. Enter the name and IP address of the server.

4 . Enter the port number and select the type of protocol using which the log files would be sent to the Syslog server. You can select TCP, UDP or the TLS protocol from the drop down list.

Note: To send log files securely, use the TLS protocol. Port number 6514 is automatically configured if you select TLS protocol. Similarly Port 514 is selected if you select the TCP or UDP protocol

Logs and Reports

5. Browse and select the certificate file to be uploaded if you have selected the TLS protocol.

Open

6. Click Save. The syslog server is added to the list.

Note: You can add only 2 syslog servers. Note: In the Interzone firewall rules, you must the allow the port number which is configured (default is 514) for the syslog communication to happen across the firewall zones if you select TCP and UDP protocols. Similarly, you must allow port 6514 to communicate across the firewall if you select TLS as the protocol.

See example:

If the SYSLOG server is running in DMZ zone then the firewall configuration is: ALLOW 514 for UDP protocol FROM UTM to DMZ. If the user has selected TCP protocol then configure as ALLOW 514 for TCP protocol FROM UTM to DMZ.

Enabling the syslog service

1. Navigate to Logs and Reports > Settings > Remote Syslog Server.

Open

2. Enable the Syslog server from the displayed list of remote servers using the corresponding status toggle button.

3. Enable the Remote Syslog service by toggling the Remote Syslog Service status button

VERIFICATION OF CONFIGURATION

Verification can be done either from CCE Server or from UI.

Using UI

STEP 1: Login to UI >> SYSTEM

Open

STEP 2: >> LOGS AND FLOWS COLLECTION STATUS .

Open

STEP 3: >>Inside SOURCE DEVICE IP, IP will reflect.

Open

Using CCE SERVER

“sudo tcpdump -i any host 514 (for logs) and 9995 (for flows) and host <IP address> -AAA” command should be ran on CCE server to check whether or not we are getting logs .