Overview

We are providing you with the steps to integrate your Watchguard Firewall with Seceon SIEM so One can have Comprehensive visibility and Proactive Threat Detection in your Environment. There will be a log transfer between your firewall to APE(Analytics and Policy Engine) via CCE (Collection and Control Engine ). In this document, we are guiding you through the steps for Log and Netflows forwarding.

Steps of Configuration

1-Connect with the system manager. 

2- Connect to the device and log

3-Go to the policy manager.

Syslog

Go to Setup and log in.

Add for new configure

Fill out and check the box

After completing all check the ok button.

NetFlow

Enable the NetFlow and check the box with the requirement.

VERIFICATION OF CONFIGURATION

Verification can be done either from CCE Server or from UI.

Using UI

STEP 1: Log in to UI >> SYSTEM

STEP 2: >> LOGS AND FLOWS COLLECTION STATUS.

STEP 3: >>Inside SOURCE DEVICE IP, IP will reflect.

Using CCE SERVER

“sudo tcpdump -i any host 514 (for logs) and 9995 (for flows) and host <IP address> -AAA” command should be running on the CCE server to check whether or not we are getting logs.