Table of Contents | ||||
---|---|---|---|---|
|
Overview
The following commands configure a ZyXEL switch, sampling packets at 1-in-1024, polling counters every 30 seconds and sending sFlow to an analyzer (CCE IP) over UDP using the default sFlow port (6343):
Steps Of Configuration
Code Block |
---|
sysname(config)# sflow sysname(config)# sflow collector <CCE IP> udp-port 6343 sysname(config)# interface port-channel 1-24 sysname(config-interface)# sflow collector <CCE IP> poll-interval 30 sampling-rate 1024 sysname(config-interface)# exit sysname(config)# exit |
VERIFICATION OF CONFIGURATION
Verification can be done either from CCE Server or from UI.
Using UI
STEP 1: Login to UI >> SYSTEM
...
STEP 2: >> LOGS AND FLOWS COLLECTION STATUS .
...
STEP 3: >>Inside SOURCE DEVICE IP, IP will reflect.
...
Using CCE SERVER
“sudo tcpdump -i any host and 6343 host <IP address> -AAA” command should be ran on CCE server to check wheather or not we are getting logs