Overview

The Syslog protocol is enabled on most network devices, such as routers and switches. Dedicated Check Point server that runs Check Point software to inspect traffic and enforce Security Policies for connected network resources. to the Syslog server in syslog format

STEPS

1. Log in to your checkpoint firewall

2. Under System Management , go to system logging and click on "Add"

3. Put your CCE IP address which will be receiving the syslogs .

4.Select "All" as a priority and click "OK"

5 . You will see your Remote server IP in the list

Image Added

Verification

• VERIFICATION CAN BE DONE IN TWO WAYS :-

                 1.By checking on UI 

                 2. Checking logs through CCE server

Verification through UI 

• Open UI >>System tab >> Logs and flows collection status:

Image Added

• The IP will reflect below source device IP 

Image Added

Verification Through CCE server

• Run the command " sudo tcpdump -i any port 514 and host <IP address>

Image Added