...
| Table of Contents |
|---|
Overview
Pre-requisite
If you specify an sFlow Agent or sFlow Collector IP address, both must be of the same type: IPv4 or IPv6.
If you do not specify an sFlow Agent address but specify an sFlow Collector, then the Collector address type must be the same as the IP Address of the management interface on the switch.
If you specify an sFlow Agent IP address, the address will be a unique IP address for the sFlow agent on a specific switch, and therefore you should not apply this sFlow configuration to multiple switches or to entire fabrics.
If you do not specify an sFlow Agent IP address, the sFlow agent will use the IP address of the management interface on the switch. To add an
Steps for sFlow configuration
...
Aruba Fabric Composer, select Configuration > System > sFlow.
Select Actions > Add. The sFlow Configuration window opens.
In the Name page, complete the following fields:
...
10. Click Apply to apply the sFlow configuration or Cancel to exit without saving.