Step1: Open Oracle VM VirtualBox Manager
...
Now click on storage -->Empty -->Disk symbol and choose seceon iso-->OK
...
Step8: In Network option NAT should be selected.
...
Ensure that the “INSTALLATION DESTINATION” under the “SYSTEM” is “Custom partitioning selected” as shown in the figure below:
...
CentOS Installation- Seceon Setup-Installation Destination
At times, when there remain some issues with the Disk space allotted, the disk portioning is not done automatically. In such cases, the INSTALLATION DESTINATION shows “Kickstart Insufficient” as shown in figure:
...
CentOS Installation- Installation Destination-Kickstart Insufficient
STEP 13: Network & Host Name Setting
.Scrolling down in the same screen, choose the option “NETWORK & HOST NAME” as shown in the figure below:
...
Network & Host Name
It can be either manually configured with a static IP address or a pre setup interface can be enabled to auto populate it via DHCP.
...
Ethernet Connection
For Manual Configuration using a Static IP: Put the Ethernet Connection as “OFF” as it has to be configured and then switched on.
...
Ethernet Connection
Now scroll down the screen and click on “Configure” as shown in the screen below:
...
Network Configuration
After Clicking on “Configure”, It takes in to a screen asking for the network configuration details as shown in the figure below:
...
Network Configuration
Go to the IPv4 tab of the screen as shown in figure below:
...
IPv4 Configuration
Put the Method as
“Manual”, Click “Add” and then provide the Client’s network details in the boxes shown in the figure above.
...
Step14. After providing all the details, click on “Save”
...
IPv4 Configuration
Switch on the Ethernet Connection as shown in the figure below:
...
IPv4 Configuration
Click “Done” from the top left corner as shown in the figure below.
...
Power ON Ethernet
14. User will get into the Home Configuration screen again and check User’s Network & Host Settings as shown in the figure below:
...
Installation Summary
STEP 15: Begin Installation
To start the process, Click “Begin Installation” as shown in figure below:
...
Begin Installation
Please note that Installation Details remains as Custom Partitioned (Unlike the Installing CentOS 7 with Minimal setup).
...
As the User clicks on “Begin Installation”, it takes to a screen as shown in the figure below:
...
User Settings
On selecting the “ROOT PASSWORD” option, User will get into a screen as shown below:
...
Root Password
It will require the user to enter a confidential Root Password; confirm it and then click
...
User will get into a screen as shown below:
...
User Settings
Additional user for this can also be created here if required. By default the ISO has one additional user “seceon”.
After the complete installation as shown in the figure below, click on “Reboot”
...
Installation Complete
STEP 17 Login to the machine
...